Wash & Wax
Diamond Luster Wash & Wax is a highly concentrated liquid especially formulated for washing automobile finishes.  It drains without streaking and will not remove wax.  Do not wash car in the sun or when the finish to hot. For best results:

1. Use one capful to two gallons of water.  Use a jet of water from a hose to create heavy foam.
2. Apply solution liberally with a Microfiber Wash Mitt.  Rub slightly to remove stubborn dirt.
3. Wash one section of the car at a time then rinse thoroughly with clean water before it dries.
4. Properly rinsed, the car will drain dry.  However, you may wish to wipe areas with a Microfiber Towel to avoid water spots. 
5. For longer and extended protection, use Diamond Luster Wax after washing.

Nothing beats a hand wash and dry!  We recommend washing your vehicle every week.  This will help protect against the harsh elements of ultra-violet rays, acid rain, dirt, and road salt.  Without the proper protection, your paint will fade, peel, and chip.

Wax
Diamond Luster Wax is a non-abrasive auto polish that adds extra gloss and protection to your vehicle's finish.   It can also be used to restore oxidized finishes.  Use regularly to keep your vehicle looking new. Keep the wax from freezing by storing the bottle at room temperature.  Avoid waxing in direct sunlight. 

1. Shake well before using.
2. Use only on clean surfaces.  For best results, wash your car with Diamond Luster Wash & Wax prior to waxing. 
3. Apply a small amount of Diamond Luster Wax on a Microfiber Wax Applicator Sponge.  A quarter sized dollup should is suggested.  While polish is still wet, buff dry with a Microfiber Towel.    

We recommend waxing your vehicle once every two to three months.

Black Beauty Protectant
Black Beauty is ideal for use on automobiles inside and out (vinyl, convertable tops, leather, rubber and plastic bumpers, dashboards, etc.)  It will revitalize and restore to a "like new" finish.  It is a non-oily protectant so it will not leave a greasy film to collect dust.  Use regularly to clean and protect. 

1. Clean the area thoroughly with a Microfiber Towel or Microfiber Hand Duster. 
2. Make certain the area is dry. 
3. Spray or wipe on with a Microfiber Applicator Sponge or Microfiber Towel and spread evenly to allow Black Beauty to penetrate and dry. 
4. Buff off excess for an even shine.  Get even better results with two applications.
5. Re-apply as needed.

Note: Black Beauty is not recommended for floors.  Avoid overspray on floors.  Hard surfaces and floors will develop slippery spots.